Magna-Matic Corporation - W4599 County Road IW - Waldo WI 53093 USA - Phone: (920) 564-2366 - FAX: (920) 564-2368 - Toll Free USA & Canada
1-800-328-1110
http://
www.magna-matic.com
- email: [email protected] © Copyright 2023 All rights reserved
Installing the **OPTIONAL** 200-20 Stand Mounting Brackets for hanging the
MAG-200 on the MAG-10400 Series Stands
1. Remove the yellow bottom cover
2. Remove the 5/16-18 bolts and nuts from the MAG-200 body. These bolts/nuts act as plugs if the brackets
are not installed.This hardware is used to connect the brackets to the MAG-200.
3. The brackets interlock - make sure the hook end is pointing downward.
4. The long support bracket fits on the inside to make the bottom bracket more rigid, this bracket shares two
#10 screws from the body.
5. Mount the other two brackets on the MAG-10400 stand, with the hooks facing upward.
6. The hooks will interlock and allow the MAG-200 to hang on the MAG-10400 stand or other surface.
MAG-200 Mounting for MAG-9000 / MAG-8000 / MAG-12008
The best placement on the stand for the MAG-200 is on the right side of the
stand as shown in the two images. This way the hose is out of your way when
sharpening or balancing lawn mower blades. It also provides the best access to
the ON/OFF switch.
200-20-Kit
MAG-200 Mounting on MAG-8100 / MAG-8200
The best placement on the stand for the MAG-200
is on the left side of the stand (under the grit guard) as shown in
the two images.
Installing the **OPTIONAL** 200-70 Spark Arressting Box
1. Remove the inlet flange
2. Unclamp the base of the 200-70 Spark Box
3. Screw the spark box base where the inlet was with the 4 self-tapping screws
4. Clamp the spark box to the base
5. Screw the inlet to the top of the spark box with the 4 self-tapping screws
The 200-70 Spark Arresting Box is designed to disrupt the flow of sparks and give them more time to cool off as another
layer of fire safety for the MAG-200 Dust Collector. While the MAG-200 has an internal spark arresting filter if you are using a
abrasive belt grinder of any kind we require this spark arresting box to give heavy spark flow time to cool before it enters the
dust collector. This spark arresting box was specifically designed for knifemakers in mind because of their heavy grinding
needs.
The 200-70 has 5 layers of baffles inside, there are 3 closed baffles and 2 open baffles to disrupt the spark flow and give
a lot of surface area for the sparks to bounce off of to further cool them before they enter the impeller and internal spark
arresting filter of the MAG-200 Dust Collector. The 200-70 is made from all steel and powder coated to last in an industrial
environment.
If you have an extreme spark load multiple spark boxes can be stacked upon each other for even more layers of fire safety.
