Installing the **OPTIONAL** 200-20 Stand Mounting Brackets for
hanging the MAG-200 on the MAG-10400 Stand
1. Remove the yellow bottom cover
2. Remove the 5/16-18 bolts and nuts from the MAG-200 body. These bolts/nuts act as
plugs if the brackets are not installed.
This hardware is used to connect the brackets to the MAG-200.
3. The brackets interlock - make sure the hook end is pointing downward.
4. The long support bracket fits on the inside to make the bottom bracket more rigid, this
bracket shares two #10 screws from the body.
5. Mount the other two brackets on the MAG-10400 stand, with the hooks facing upward.
6. The hooks will interlock and allow the MAG-200 to hang on the MAG-10400 stand
or other surface.
Best Placement for MAG-200
Typically the best placement on the stand for the MAG-200
is on the right side of the stand as shown in the two
images. This way the hose is out of your way when
sharpening or balancing lawn mower blades. It also
provides the best access to the ON/OFF switch.
200-20-Kit
Magna-Matic Corporation - W4599 County Road IW - Waldo WI 53093 USA
Phone: (920) 564-2366 - FAX: (920) 564-2368 - Toll Free USA & Canada
1-800-328-1110
http://
www.magna-matic.com
- email: [email protected] © Copyright 2020 All rights reserved
