Magmaweld monoTIG 165ip, Руководство пользователя

Страница: 21 / 136

EN
21 monoTIG 165ip / monoTIG 200ip
www.magmaweld.com USER MANUAL
Example :
If you have a 100 A initial current, the crater current (ending current) will be 30 A.
Indicates that if the end ramp time is set to 1 sec, it will also decrease from the main
current to the crater current for 1 sec.
• There is the final gas time after the crater current. The final gas time is set between
0-20 sec. This time may vary depending on the user’s request.
• In case of complaints such as darkening at the end of welding or deformation at
tungsten tip , it will be necessary to increase the final gas time.
In 4-Trigger mode;
• When you press the trigger, pre gas comes out. Starts welding in ignition current after
pre-gas is received. As long as the trigger is not released, the machine continues to weld
in the ignition current, when the trigger is released, it makes the ramp for the set ramp
time and continues welding at the main current.
• When you press the trigger again and when you want to end the welding, the ramp time
starts to advance and continues on the ramp as long as you press and hold the trigger.
• When the ramp time is over, it will waits for crater filling and allow you to fill the crater.
• After the crater is over, you can release your hand from the trigger.
• Cools the workpiece during the final gas period and you will complete the welding process
by this means.
In 4-Trigger Mode, the TIG Curve operates as follows;
• In 4-trigger mode all menus and settings in the 2-trigger mode shall apply in the same way.
In 4-trigger mode, unlike 2-trigger modes, the repair current in the TIG curve will also be
active. Repair current is only used with multi-function torch in 4-trigger mode.
• It is used to correct errors during the repair current welding process.
• The repair current is determined in terms of %. It is in the range of 1-100%. If the machine
is 100 A and the repair current is 50 A, then this means the repair current is set to 50 A,
which is 50% of the main current. The level of the high and low currents will be set here.
Example :
If the main current 100 A is set to 50 A and the repair current is set as 50 A and if the
machine is using a multi-function torch, the machine uses 50 A when the machine is welding
at 100 A and the repair current button is pressed over the torch.
Thus, if there is a possible defect in the welding seam, the machine will be switched to low
current and the required repair will be done in order to prevent drilling in the heated area.
Afterwards, when the main current button is re-pressed over the torch, the machine
recovers to 100 Amperes and the user may resume the welding process.
PrG :
Initial Gas Time
I :
Welding Current
PoG :
Final Gas Time
Operation