Magmaweld ID 300E, Руководство пользователя

Страница: 11 / 72

EN
11
www.magmaweld.com
ID 300E
USER MANUAL | РУКОВОДСТВО ПО ЭКСПЛУАТАЦИИ | KULLANIM KILAVUZU
TECHNICAL INFORMATION
1.1 General Information
Figure 1 : ID 300E
1-
Handle
7-
Arc Force Adjustment Pot
2-
Current Adjustment Pot
8-
Welding Mode Selection Button
3-
Digital Display
9-
Earth Cable and Welding Cable Socket (-)
4-
Digital Display
10-
Mains Cable Inlet
5-
Earth Cable and Welding Cable Socket (+)
11-
Remote Control Connector Inlet
6-
Hot Start Adjustment Pot
12-
ON / OFF Switch
10 12
11
5 9
1
2
3
4
6
7
8
ID 300E is an inverter type portable, tri-phase (400VAC 50-60Hz) DC MMA welding machine designed to
weld stick electrodes up to 5.0 mm designed regarding for the related phase-notr voltage. Must be used at
3 phase, 4 wire and notr grounded systems. Due to descending characteristics of the inverter technology it
provides stable arc and good re-striking performance. Initial striking ability of the electrodes can be
improved via Hot Start potentiometer and certain electrodes like basic electrodes which have tendency to
short circuit and stick to the weld pool could be avoided by adjusting the Arc Force potentiometer. It can be
used as a Touch-Scratch DC TIG welder if a TIG torch with a valve is connected. The electric consumption is
approximately 10% less than the silicon controlled rectifier equipments and 25% less than the magnetically
controlled equipments. ID 300E can also be used with long welding cables up to 25 m. Plus, wireless and
cable remote control options are possible. The machine is fan cooled and thermally protected against over
heating.
1.2 Machine Components
Technical Information