5
4. INSTALLATION AND MOUNTING
This type of equipment should be installed and mounted by qualified and experienced
technicians.
4.1 IMPORTANT SAFETY INSTRUCTIONS
Please, follow these instructions while installing the cabinet:
•Personnel responsible for moving and installing equipment must have flexible and non-slip work
gloves, safety glasses, and safety shoes that must be used whenever necessary.
•Follow the instructions in the "Installation" section of the current manual and additional
guidelines, if applicable.
•Do not walk on the equipment.
•Do not install and use the equipment if it is damaged.
At installing the device near a wall, respect the distance of not less than 60 mm.
4.2 EQUIPMENT MOUNTING
Thoroughly remove any polyethylene film protecting the components and parts of the display
cabinet.
If this manual contains a Chapter with installation Instructions, follow the sequence indicated for
proper installation.
Align the display case in a horizontal position by adjusting the leveling feet.
Use only hand tools to fix screws when mounting glass components and parts.
We recommend installing, if necessary, mechanical protection devices adapted to the equipment
to prevent possible damage, for example, from the impact of a trolley, a polisher, a loader, etc.
4.3 ADJUSTMENT OF THE FRONTAL GLASSES
Adjustment of the frontal glasses should ensure minimal and sufficient clearance between them
in 'lowered' and 'lifted' positions. A contact of glasses is unacceptable.
4.4 POWER SUPPLY CONNECTION
Make sure the voltage of the electric supply corresponds to the data specified on the nameplate
of the device. Deviations in the electric supply circuit voltage should not exceed ±10% from those
specified on the nameplate.
The equipment does not have any protection from overvoltage, so it is recommended to check
the safety level of the electric circuit to which the device will be connected to.
The device has a terminal for connecting with a potential equalization connector when it is
necessary to prevent the presence of voltage when touching between the grounding equipment
and metal parts that may accidentally come into contact with current-carrying electrical wires.
This terminal, marked with the corresponding symbol, is located in the electronics unit and is
intended for connection to the ground circuit with a wire with a cross section of 2.5-6 mm2.
Connect the equipment to the electrical network only at the end of installation.
