Magio MG-965, Инструкция по эксплуатации

Страница: 22 / 25

22
Before first use
Operation
EN
After transportation or storing the device at a low temperature, keep it at room
temperature for three hours at least.
1. Check the integrity of the device. If it is damaged, do not use it.
2. Remove all the stickers and packing materials that are obstructing the device
operation.
3. Wipe carefully the inside of the appliance with a wet cloth.
1. Unpack the thermo pot.
2. Before switching on make sure that your home electricity supply corresponds to
the voltage of current specified on the housing.
3. Open the lid (10), by pressing the button (6) and holding it (figure below).
The upper lid is removable. You can remove it by lifting it 45 °C and pressing
the lid clamp located on the back of the cover. Pull it up under the 45 °C
4. Fill the thermo pot with water, using the special cup. Do not overfill, fill to the «FULL»
mark (inside the case).
5. Insert the power cord (18) plug into the power cord jack (14) on the case and the
plug into the socket.
6. Press the «Temperature set» button (page 20) on the control panel to set the
needed temperature.
After the thermo pot boiles, it will start keep warm mode to keep the temperature
that was set before. The red boiling light indicator goes out and the green boiling
indicator will light up.
45 °С
Attention! Do not remove the lid while the water is boiling.