22
Cyclone dust collection system
The cyclone system does not require a dust bag. Dust particles are sucked into the dust
collector by a stream of air. The air is cleaned with a protective filter, which is installed at the outlet
of the dust collector.
Before installing the dust bin into the vacuum cleaner body make sure that the HEPA filter is
dry and there is no moisture inside the dust bin.
Never use the device without a filter installed, or with a damaged or dirty filter. Otherwise, dust
will fall into the motor and cause to damage of the device.
Clean and care
Cleaning the dust container.
1. Turn off the device and unplug the cord from the outlet.
2. Holding the handle, move the dust bin lock button and remove the dust bin from the vacuum
cleaner body pulling upwards. (Pic.8.1)
3. Press the dust bin lid release button and open the dust bin lid. (Pic.8.2)
4. Place the dust bin above the trash bin, turn the dust bin upside down and remove the dust and
garbage.
5. Close the lid and make sure that the lid is fixed properly.
6. Install the dust bin back to its place.
Cleaning the HEPA filter in the dust bin
1. Preliminarily remove dust and garbage from the dust bin as described above.
2. Remove the HEPA filter (pic. 9.2).
3. Clean the HEPA filter from dust and garbage and wash the HEPA filter under warm water jet.
4. Dry the filter thoroughly.
5. Wash the dust bin, wipe it and dry.
6. Install the HEPA filter back to its place.
7. Install the assembled dust bin back to it’s place.
Notes:
»
Wash the HEPA filter, directing the water jet to the outer side of the HEPA filter.
»
Do not wash the filter in a dishwashing machine.
»
Do not dry the HEPA filter with a hairdryer.
»
If you cannot install the dust bin to its place, check whether the HEPA filter is installed properly.
Cleaning the outlet HEPA filter
1. Switch the vacuum cleaner off and unplug it.
2. Remove the outlet filter grid, press the clamp and remove the HEPA filter.
3. Wash the HEPA filter under slightly warm water jet.
4. Dry the HEPA filter.
5. Install the HEPA filter back to its place.
6. Install the outlet filter grid back to its place.
Notes:
»
Wash the HEPA filter, directing the water jet to the outer side of the HEPA filter.
»
Do not wash the filter in a dishwashing machine.
»
Do not dry the HEPA filter with a hairdryer.
Before installing the HEPA filter make sure that it is dry.
EN
Содержание MG-892
Страница 2: ......
Страница 6: ...4 МАЛЮНКИ РИСУНКИ PICTURES UA RU EN ...
Страница 7: ...5 2 1 2 1 1 2 МАЛЮНКИ РИСУНКИ PICTURES UA RU EN ...
Страница 27: ...25 ...