Magio MG-450, Инструкция по эксплуатации

Страница: 20 / 22

20
EN
1. Unpack the unit completely and remove any stickers that can
prevent unit operation.
2. Check the unit for damages; do not use it in case of damages.
3. Before switching the unit on, make sure that your home mains
voltage corresponds to the unit operating voltage.
4. Wash the flask, filter, all removable parts with water and a neutral
detergent, rinse thoroughly and dry. Wipe the body with the clean,
damp cloth.
5. Dry all parts of the appliance and carry out a full brewing cycle in
accordance with the section «Brewing coffee» without filling coffee
in the filter.
1. Place the appliance on a flat, stable surface.
2. Open the lid of the water tank, fill it with clean drinking water up to
the maximum mark («MAX») that is indicated inside the tank.
3. P ut the required amount of ground coffee in the filter, gently shake
the filter to distribute the coffee evenly, place the filter in the coffee
maker and close the lid.
T he recommended amount of coffee for 1 cup is 1 teaspoon.
You can adjust this amount to your taste.
4. P lace cups under each coffee outlet.
5. After making sure that the power supply parameters match the
data indicated on the device, connect the device to the network
and press the power button (Start). Wait until the coffee process is
complete (all coffee drains into cups).
6. The coffee maker will turn off automatically when the filtering
process is complete and the indicator will turn off.
7. After each work cycle, allow the appliance to cool.
»
T o interrupt the cooking cycle, unplug the power cord from the
outlet.
The volume of water in the tank corresponds to the volume of
two cups that are supplied.
Brewing coffee
Note:
There will be less finished coffee, since ground coffee absorbs
part of the water.
During brewing, do not open the lid of the water tank or slide the
flask.
The appliance is intended only for preparing a drink from ground
coffee!