MAGINON MPP 10000-SF, Инструкция по эксплуатации

Страница: 17 / 28

Commissioning
15
Contact the manufacturer at the service address indicated
on the warranty card.
Preparing the power bank
− Remove packaging material and all protective foil.
Charging the power bank via mains
adapter
Fully charge the battery before using the power bank.
The charging time of the battery depends on the selected
charging source and its output power. Only use the supplied
Micro USB charging cable
2
. Connect the cable to the
Micro USB port
8
between the two USB outputs. Connect
the other end of the cable to a mains charger (optional, not
supplied) or a car charger (optional, not supplied).
− Only use power supplies with an output
voltage of 5 V and an output current of at least
2 A to charge the power bank.
− Due to the input current of 2 A, USB
connections on computers or laptops must not
be used to charge the power bank.
Charging the power bank with sunlight
You can charge the power bank with
3
the solar panels.
Make sure that the solar panels
3
receive enough sunlight.
As soon as sufficient sunlight is available, the solar status LED
glows
5
constantly green.
If the solar status LED
5
is not lit, there is not enough
sunlight. In this case, change the position of the unit or
expose it to direct sunlight.
To check the charging status, switch on the power bank.
The battery status indicator LEDs light up depending on the