AFTER SALES SUPPORT
AUS
1 800 623 432
AUS
32
Using the camera
−
Timer: Off
/On
Set timer to “On” if camera should only be active within a
certain time. Once “On” has been confirmed with the OK
button, the start and end time can be set.
If the start time is, for instance set to 18:35 hrs and the end
time to 8:25 hrs, the camera will be operational from 6:35
pm of the current day until 8:25 am of the following day.
The camera will not be triggered and will not take any
photos or videos outside of this period.
−
Password: Off
/On
After selecting “On” enter a four-digit password to protect
your camera against unauthorised access. This password
must be entered each time the camera is switched on in
the Test mode before the camera can be used.
If you have forgotten your password and are unable to use
your wildlife camera, the camera and till receipt must be
returned to our Service department. This is the only way to
prevent unauthorised access to your camera.
−
Serial no.:
Off
/On (can only be used for photos not for
videos)
Select “On” to assign a serial number to the camera. As
soon as “On” has been confirmed by pressing the OK but-
ton, the individual serial number can be inserted.
You can use a combination of 4 digits and letters to docu-
ment the location on the photos (e.g. YSP1 for Yellow Stone
Park). When using several cameras this makes it easier to
identify the location when viewing photos.
−
Time lapse:
Off
/On
When “On” has been selected, the camera automatical-
ly takes photos or videos in the selected time interval,
irrespective of whether or not the PIR sensor has detected
