L25-013 Rev 0 (02/04)
Installation
1.
Disconnect the grill from its current gas supply.
2.
Remove the upper portion of the grill from its base and set aside.
3.
Turn the base over so the legs will be facing upward.
4.
Remove 2 legs from one of the far sides of the base by pulling each leg
out of its socket while depressing the snap button located on the leg.
5.
Slide the legs through the holes on the lower tank holder (item #1).
Reference illustration “B” for correct orientation of legs and holder.
6.
Reinstall legs back into the base assuring that the flanges on the lower
tank holder are facing outward.
7.
Inspect the holes located on the far side of the base. If the holes contain
threaded inserts then the tank holder plate (item #6) is not required to
complete the installation and may be discarded. If the holes are empty
then use the tank holder plate (item #6) in step 8.
8.
Using a 7/16” wrench install the hex head cap screws (item #4) into the
base. (illustration “A”)
9.
Slide the upper tank holder (item #3) though the threaded portion of the
hex head cap screws. Reference Illustration “B” for correct orientation.
10.
Secure the upper tank holder to the base using wing nuts (item #5). The
wings nuts should be tightened loosely so the upper tank bracket is
allowed to slide up and down.
11.
Repeat steps 4 through10 on the opposite side for LPG60 models.
12.
Turn the base over so it is back to its original position.
13.
Set the bottom ring of the propane tank(s) (item #2) into the notches of the
lower tank holder. Rotate the tank so the outlet valve is facing forward.
14.
Position the upper ring of the propane tank(s) so it is inside the notches of
the upper tank holder.
15.
Tighten the wing nuts until the propane tank(s) is secure.
Illustration A
Illustration B