1:
Removing old vanity (if applicable): 1) Turn off the water supply and
take the drain out. 2) Disconnect the supply lines from the faucet.
3) Remove the old vanity top and vanity.
NOTE:
If the new vanity is not
installed immediately, temporarily stuff a rag into the drain pipe.
2:
Using a level, locate any uneven floor and/or wall areas where your
vanity will be installed. Unevenness can cause your vanity to become
misaligned resulting in twisting of the cabinet. Repair any uneven areas
by reducing high spots or shimming low spots.
3:
1) Place the vanity in the desired position taking into account the location
of your plumbing. 2) Ensure the vanity is level front to back and at both sides.
4:
Secure the vanity to the wall by inserting (x 2) #8 x 2” screws (B - not
included) through the back rail of the vanity. Figure 1.
NOTE:
It is
recommended that the vanity be installed to at least one wall stud. If you
are unable to locate wall studs, it is recommended that you use wall
anchors (C - not included) to secure the vanity.
5:
Install the hardware, vanity top, faucet and drain (each not included) as
per the instruction sheets provided with those items and ensure that there is no leakage.
TROUBLESHOOTING
WARNINGS & CAUTIONS
WARNING:
Two people are required for safe installation. Take extra precautionary
measures to ensure a secure grip on the vanity base when lifting.
CAUTION:
The bathroom floor and wall must be finished prior to
installation of the vanity base.
INSTALLATION
Model 30003 shown in illustration
Figure 1
Problem:
1) Vanity doors or drawers rub against
another surface.
2) There is an uneven gap between
the doors or drawers and cabinet.
Possible Cause:
Floor or vanity is not level.
Corrective Action:
1) Use a shim to ensure the vanity is
level.
2) Adjust the door hinges or drawer
slides. Figures 2 and 3.
Side adjustment:
Using a Phillips screwdriver, rotate screw (1)
clockwise to move the door left and
counter-clockwise to move the door right.
Moves the door up to 2 mm.
Depth adjustment:
Using a Phillips screwdriver, rotate screw (2)
clockwise to move the door forward and counter-
clockwise to move the door backwards.
Moves the door up to 2 mm.
Height adjustment:
Using a Phillips screwdriver, rotate screw
(3) clockwise to move the door upward and
counter-clockwise to move the door
downward. Moves the door up to 2 mm.
Figure 2 - Adjusting Hinges
CARE & MAINTENANCE
• To maintain the beauty of the furniture finish, avoid placing the vanity in direct sunlight.
• Avoid exposing the vanity to extreme temperatures by installing away from heat and air vents.
• Dust frequently with a clean, soft and dry cloth.
• Wipe away any water or liquid spills on the vanity base immediately with a clean, soft and dry cloth.
