User documentation MAGICFX® Shot Base DMX
Page 19
13. TROUBLESHOOTING
-
The machine does not turn on.
Check if the powerCON cable is properly connected. If so, check to see if the switch
is in the ‘on’ (I)
position.
-
The machine does not respond to the DMX controller.
First check if all cabling is properly connected to the right connecting points.
Then check if the DMX control is switched on and if this is actually sending a signal by, for example,
connecting another DMX machine.
If this machine does respond then check if the addresses are properly set in the machine. Instructions
on how to do this can be found on pages 13 and 14 of this manual.
-
It is impossible to change the settings.
The machine is probably in the LOCK position. On the display
there is an L showing behind
‘Safety’.
This can be resolved by pressing down the LOCK button for 5
seconds.
-
The cable of the cannon is too short for the connection.
Use the extension piece provided to make the cable fit.
-
A cannon is not going off.
Check to see if the connector of the cannon is properly connected. If so, exchange the cannon for
another and see if this one does go off.
-
The Shot Base DMX is still malfunctioning after troubleshooting
Always contact your dealer or the technical service of MAGIC FX first in case of uncertainties,
questions about the Shot Base DMX works or other issues with regard to the Shot Base DMX.
Содержание SHOT BASE DMX
Страница 1: ......
Страница 2: ...PRODUCT CODE MFX0350 VERSION 1 0 DATE 26 02 2013...