MagicBox V1R2B, Инструкция по сборке

Страница: 6 / 20

Your PCB should look like this:
Resistors
[ ] Install the large, 1 watt , 180 Ohm (Brown-Grey-Brown) resistor at R12. This is the only 1 watt
resistor; all of the others are 1/4 watt. Note: The leads of this resistor should be bent as
shown in this detailed photo, so that it will fit the hole pattern and slightly elevate the
resistor above the board for cooling.
[ ] Install 220 Ohm (Red-Red-Brown) resistors at R36, R43 and R44.
[ ] Install 470 Ohm (Yellow-Violet-Brown) resistors at R3, R4, R14, R18, R35, R40, R42, R47 and
R48.
[ ] Install 4.7K Ohm (Yellow-Violet-Red) resistors at R1, R2, R7, R8, R9, R11, R13, R15 (next to
R18), R16, R17, R20, R21, R22, R23, R24, R26, R27, R28, R29, R30, R31, R33, R34, R37, R38, R39,
R41, R45 and R49. Since there are so many resistors of this value, it is suggested that they be installed
in groups of 7, 7, 7 and then the remaining 8, shown by the colored highlights.
[ ] Install the 36K Ohm (Orange-Blue-Orange) resistor at R25.
[ ] Install 47K Ohm (Yellow-Violet-Orange) resistors at R10 and R19.
[ ] Install the 10M Ohm (Brown-Black-Blue) resistor at R46.
6