45
3.7.9 IR Function Duplex (Half)
This item allows you to select the IR function when you select the UART
2 Mode is ASKIR
3.7.10 RxD , TxD Active (Hi,Hi)
This item allows you to determine the active of RxD, TxD.
3.7.11 Onboard Parallel Port (378/IRQ7)
This item allows you to determine access onboard parallel port controller
with which I/O address.
3.7.12 Onboard Parallel Mode (ECP/EPP)
Select an operating mode for the onboard parallel (printer) port. Normal
EPP (Extended Parallel Port) ECP (Extended Capabilities Port)
ECP+EPP PC AT parallel port Bi-directional port Fast, buffered port
Fast, buffered, bi-directional port.
Select Normal unless you are certain your hardware and software both
support EPP or ECP mode.
3.7.13 ECP Mode Use DMA (3)
Select a DMA channel for the parallel port for use during ECP mode.
3.7.14 Parallel Port EPP Type (EPP1.9)
This item allows you to determine the EPP Type of onboard I/O chip.
3.8 Load BIOS Defaults
This loads the standard BIOS default values. To select, highlight it and press
the
¡ Õ
Enter
¡ Ö
key. Then press the
¡ Õ
Y
¡ Ö
and
¡ Õ
Enter
¡ Ö
keys to
confirm. Otherwise, press the
¡ Õ
N
¡ Ö
key to cancel.
3.9 Load Setup Defaults
