Page 4 of 15
506325-01
Issue 1734
The outside of the unit may be flush with the face of
the exterior wall, and it should not be obstructed with
trees, landscape materials, or building structure. Unit
can be installed recessed with appropriate wall sleeve
accessories. There is no minimum clearance required on
locating the unit to an interior corner of a building.
If the unit is installed in a residential garage, it must be
located or protected to avoid physical damage by vehicles.
The unit must be installed so that no electrical components
are exposed to water.
This unit must be installed level to allow for proper
drainage of the unit base pan and indoor drain pan.
CAUTION
Wall Sleeve and Louver Grille Installation
Refer to installation instructions included with the wall
sleeve kit and the louver grille kit along with Figure 2 for
guidance in assembling and installing the wall sleeve and
louver grille.
The sleeve is not intended as the sole support for
the unit. An additional support must be provided for
adequate support (see Figure 2).
CAUTION
Installing and Securing Unit to Wall Sleeve
1. Make sure the gaskets attached to the sleeve are not
damaged.
2. Verify divider panel is positioned properly. Figure 3
shows the correct position for 48” and 56” tall units
(flange pointing up). For 43” tall units, the divider panel
should be positioned so the flange points down.
3. Place the MHP unit into the wall sleeve.
Lift leading
end of unit and walk unit onto the sleeve.
Once in
the sleeve, lower the unit into position. This prevents
damage to the base pads. Assure that the unit is level
and completely seated against the gaskets on the wall
sleeve.
Figure 2. Wall Sleeve and Louver Kit Installed
NOTE:
Platform must be constructed so that it is level with sill plate of wall opening.
