Installation Of CO
2
Cylinder Support
Install the metal support provided onto the 4 studs located on the exterior back wall. Align the
holes in the support with the studs and push down firmly. (See Figure 1)
Installation Of CO
2
Cylinder
Install your fully charged cylinder into the support stand.
Installation Of CO
2
Regulator
Attach the CO
2
regulator to the cylinder by turning the regulator nut onto cylinder valve, making
sure washer is securely inserted into connecting nut. Tighten snug using an adjustable wrench
(not supplied) and assure there are no leaks. (See Figure 2)
Installation Of CO
2
Air Line Outside Cabinet
Remove plug located at the exterior back (top left hand corner).
Save it for later use if you decide to convert unit to an all refrigerator.
Insert the open end of the air line (red) line the cabinet through the uncovered hole.
(See Figure 4)
Installation Of CO
2
Air Line Hose To Regulator
Attach the open end of the red hose to the hose barb connection on the regulator
Secure hose by using one clamp provided. Use pliers/screwdriver to tighten clamp to prevent
leaks. (See Figure 3)
Installation Of The Beer Tower
Remove the top plug by twisting and pulling out, saving it for later use if you decide to convert unit
to an all refrigerator unit.
Unravel the beer line (clear hose) from the tower and insert the beer line and wing nut through the
uncovered hole on top.
Lock the beer tower assembly to the top and make sure to position the beer faucet so it is aligned
with the cabinet front (6 o’clock position). You accomplish this by aligning the bottom of the beer
tower to the 3 grooves on the top cabinet and tighten by hand clockwise to properly lock.
Installation Of Protective Metal Plate
This plate should always be installed when the keg is in place to protect against unnecessary
damage to the floor of the cabinet.
Installation Of The Beer Keg
Position the beer keg directly in front of the open door. Using keg handles only, carefully lift the
beer keg. (See Figure 5)
To place the beer keg inside the cabinet, brace your knees behind the beer keg. Lift the front of
the keg just enough so the front edge of the keg is resting on the front edge of the Beer Dispenser
Fig. 1
Fig. 2
Fig. 3
9
