3
SPECIFICATIONS
Model
Capacity
Jack Size (L x W x H)
Min. Height
Max. Height
JSA200LCX
2 Ton
42-1/2" x 13-3/4" x 7"
2-1/2"
20"
PREPARATION
A
ssembly
1. Assemble the two-piece handle with provided bolt
.
2. Insert handle into the handle fork. Tighten the bolt on handle fork to prevent accidental removal of handle while
in use.
WARNING:
Do not lift or carry jack by handle. Handle could dislodge and jack fall, resulting in possible injury
or property damage.
Before Use
1. Verify that the product and application are compatible, if in doubt call Mac Tools Tech Service.
2. Before using this product, read the operator's manual completely and familiarize yourself thoroughly with the
product, its components and recognize the hazards associated with its use.
3. To familiarize yourself with basic operation, locate and turn the release valve (handle):
a.
Clockwise
until firm resistance is felt to further turning. This is the ‘
CLOSED
’ release valve position used to
raise the saddle.
b.
Counter-clockwise
, but no more than 1/2 turn from the closed position. This is the ‘
OPEN
’ release valve position
used to lower the saddle.
4. With saddle fully lowered, and release valve closed, pump the operating handle. If lift arm responds immediately,
jack is ready for use. If jack does not respond, follow
Bleeding/Venting Trapped Air
procedure below.
5. Ensure that jack rolls freely. Raise and lower the unloaded saddle throughout the lifting range before putting into
service to ensure the pump operates smoothly. Replace worn or damaged parts and assemblies with Mac Tools
authorized replacement parts only.
Bleeding/Venting Trapped Air
With the Release Valve in the OPEN position (3b above) and Saddle fully lowered, locate and remove the Oil Filler
Plug/Screw. Pump Handle 6 to 8 full strokes. This will help release any pressurized air which may be trapped within
the reservoir. Check oil level and reinstall Oil Filler Plug/Screw.
!
• Study, understand, and follow all instructions
before operating this device.
• Do not exceed rated capacity.
• Use only on hard, level surface capable of
supporting the load.
• Lifting device only. Immediately after lifting,
support the vehicle with appropriate means.
• Do not move or dolly the vehicle while on the jack.
• Lift only on areas of the vehicle as specified by
the vehicle manufacturer.
• No alterations shall be made to this product.
• Failure to heed these markings may result in
personal injury and/or property damage.
To avoid crushing and related injuries:
• Never work on, under or around a load supported
only by hydraulic jack.
• Always use an identical pair of adequately rated
jack stands.
• Chock each unlifted tire in both directions.
• Do not use this device to lift, level, lower, support nor
move a house, mobile home, travel trailer, camper or
any building structure.
• Be alert and sober when using this product. Do not
operate under the influence of drugs or alcohol.
X
WARNING
!
WARNING
!
