96
Check the coolant quantity in the tank. It is normal if quantity is between full and low.
When it is below “LOW”, the coolant should be filled in using the following steps:
a)
Remove heater relief hose.
b)
Screw out the radiator cover and remove the coolant pot cap.
c)
Fill in the coolant to radiator until it reaches concave position.
d)
Unscrew thermostat relief screw (cannot fall off) drain air.
e)
Tighten thermostat relief screw after draining air, tighten torque 3.0N°m(31kgf·cm)
and add coolant from coolant filler hole.
f)
Repeat item 2~3 three times until coolant leak from bleeder screw.
g)
Add coolant continually into radiator and coolant pot to “FULL” mark.
h)
Insert air relief hose of heater screw radiator cap and pot cap.
i)
Allow engine to run at speed 2000r/min over until the fan begins to run. Stop running
engine, add coolant into radiator and coolant pot when the engine is cold.