Page 11 of 19
7 - Connect the input cable to a power supply. This must be carried out only by a qualified electrician.
NOTE
Points 8 and 9 only apply if a chemical detergent is to be used.
8 - Place an approved detergent container adjacent to the machines detergent tube.
9 - Remove the detergent tube from the stowed position and place in the detergent container. Ensure
the detergent tube filter is submerged in the detergent.
SWITCHING ON/SWITCHING OFF PROCEDURES
Control panel
The control panel consists of switches and controls as follows:
Power ON/OFF Switch
Power on Warning Light (Green)
Heating elements ON/OFF Switch
Heating element warning light (Orange)
Low water warning light (Red)
Water temperature digital readout display
SWITCHING ON
To switch the machine on, proceed as follows:
1.
Ensure the power ON/OFF switch is set to 'OFF'.
2.
Switch on the external water supply to the machine.
3.
Switch on the external power supply.
4.
Move power switch to the ON position and ensure the power on lamp is illuminated.
5.
Switch on the heaters and allow approximately 90 minutes for the immersion heaters to heat the
water in the tank to the maximum operational temperature.
CLEANING OPERATION
1.
Before using the machine ensure that all hoses, guns and lances are in good condition and are correct
for the application.
2.
Switch the machine on by moving the main ON/OFF switch on the controls to the START position. The
switch is sprung loaded and will return to the ON position. The machine will pressurise once the
trigger is operated.
3.
On pulling the trigger you should hold the gun and lance with both hands placing one of your hands
on top of the lance to hold it steady.
4.
Upon releasing the trigger, the machine will enter by-pass mode.
5.
Upon re-pulling the trigger the machine will automatically restart and be ready for use. If the trigger
is not re-pulled within 3 minutes the machine will shut down and will need to be reset.
6.
Once cleaning has been completed switch off the machine using the main ON/OFF switch.
The machine should be turned off after every use and left in a safe condition. Failure to do so may
cause unwanted damage and breakdowns of the machine.
