Mafell LO 65 Ec, Перевод оригинальной инструкции по эксплуатации, Страница: 23 / 162

-23-
5.1.1 Switching on and off (see Fig. 1)
Danger
Only switch on the machine if the
milling cutter has no contact with
the workpiece.
•
Switching on: Press rocker switch 42 at the end
designated with I.
•
Switching off: Press rocker switch 42 at the end
designated with O. The electronic brake causes
the machine to come to a standstill very quickly.
5.2 Speed adjustment (see Fig. 1)
Which speed has to be set for which milling cutter-Ø
and material can be gathered from the depicted
diagram and from the front of the machine.
The electronic system keeps the set speed constant.
In addition, the electronic system adjusts the motor
down in case of overload, i.e. the tool will stop. The
machine must then be switched off. Switch on the
machine again afterwards and continue to work with
reduced feed speed.
Danger
Do not work with the router if the
electronic system is defective, as
this may lead to excessive speeds.
5.3 Milling depth adjustment (see Fig. 1)
5.3.1 Clamping device
By turning handle 25 clockwise you can lock the
machine at any milling depth.
5.3.2 Return stroke limit
To avoid unnecessary empty strokes, you can reduce
the stroke to the required length by adjusting knurling
nut 28.
5.3.3 Revolving depth control turret
The revolving depth control turret 12 can be used to
set three different milling depths. The longest of the
stop screws 85 is set to the smallest milling depth while
the shortest stop screw 83b is set to the largest milling
depth.
5.3.4 Adjustment of milling depth according to
scale
•
Clamp the milling cutter and place the machine
onto the workpiece.
•
Unscrew the clamping and contact the workpiece
surface with the milling cutter. Then clamp the
machine again.
• Adjust depth stop 45 up to the stop screw.
•
Set the top edge of the slidable needle 19 on the
depth stop to the zero point of scale 43.
•
Set the depth stop to the desired milling depth
and clamp it with the clamping arm 68c.
•
The empty stroke can be reduced to approx. 10
mm with knurling nut 28.
•
If you release the clamping at the machine, the
reverse stroke will be carried out automatically.
5.3.5 Fine adjustment of milling depth
A fine adjustment of the milling
depth can be achieved by turning
adjusting nut 30. One turn of the
adjusting nut causes a milling
depth adjustment of 1 mm.
5.4 Work instructions
Hold onto the machine with both
hands during operation.