Maestro MR 201, Руководство пользователя

Страница: 4 / 23

6 7
- Do not use while bathing or in a shower.
- Never drop or insert any object into any opening on this appliance.
- Hair sprays and fixers contain inflammable components. Do not
use them when the device is ON. Do not direct sprays of any kind or
water on the device.
- Before using the device, wipe the hair with towel.
- It is forbidden to close the inlet and outlet openings on the device.
- From time to time clean the intake grille to prevent any blocking air
intake. Make sure that there is no objects, hair in the suction pipe. If
airflow is blocked while the hairdryer operates (e.g., by hair or pile,
or by hand), the device automatically turns off. Once it has cooled
down (after a few minutes), it is automatically switched on again.
Despite the fact that the device is equipped with protection against
overheating, it can be damaged, if air flow stops.
THIS APPLIANCE IS FOR HOUSEHOLD USE ONLY. DO NOT
USE THE APPLIANCE FOR ANYTHING OTHER THAN INTENDED
USE.
Do not use it for commercial purpose.
Actions in extreme situations
- If your device has fallen into water or water has penetrated it,
immediately disconnect it from the mains without contacting the
device itself or the water.
- If there appears smoke, sparkling, strong smell of burning
isolation, immediately stop using the device, disconnect the device
from the mains and apply to the nearest service center.
Operation
Before startup
- Remove all wrap materials and stickers
- Make sure that all the parts of appliance don’t have damages.
- Unwind the power cord completely.
ATTENTION! A small quantity of smoke or a specific smell may
appear after the first switching ON as the result of conservation
materials contact with heating element. This is a normal
phenomenon and it shall disappear after several minutes of
operation.
Open the handle (E/Pic.1), until the folding mechanism gets in to
the lock position (С/Pic.1).
- Before switching on the hairdryer to the power supply, make sure
that the device switch (A / Pic.1) is set to “0” (OFF).
- Connect the device to the power supply.
- Choose the desired operating mode by the Switch (A /Pic.1):
CAUTION: If the hairdryer stopped its work for an unknown reason,
just set the switch A to position “0” off and unplug the device.
Let it cool down. Then check the air intake grille, and in case of
contamination clean it or hold the hairdryer a little further away from
the hair while operation.
EN
Position
of the switch
Designations Function
А0 0 (OFF) - the device is switched off
А1 I First rate uses half of the power
of the device, used for delicate
hair drying and for modeling.
А2 II The second speed includes the
entire capacity of the device and
is used for rapid hair drying.