AP-WRC4 Installation
With
EV-100 Evolution Autopilot
www.madmanmarine.com
5-way Connector
Backbone
Terminator
Removed
Terminator
New SeaTalk
ng
Backbone Cable
Steps (continued):
3.
Remove the terminator from the SeaTalk
ng
backbone ‘Tee’ connector
so that the backbone
can be extended.
4.
Insta
ll the terminator that was removed from the ‘Tee’ connector on one of the blue ports of
the SeaTalk1 to SeaTalk
ng
converter. Refer to Figure 3 for this and subsequent connections.
5.
Connect one end of a
new
SeaTalk
ng
backbone cable to the
‘Tee’ connector (where the
terminator was removed) and the other end to the other blue port on the SeaTalk1 to
SeaTalk
ng
converter.
6.
Terminate the wires of the SeaTalk cable in the AP-WRC4 terminals as follows:
Wire
Function
Terminal Symbol
Red
+12V
Yellow
SeaTalk
SeaTalk
Screen/Shield
0V
Screen
7.
Plug the yellow connector of the SeaTalk cable into the yellow port of the SeaTalk to
SeaTalk
ng
converter.
8.
Turn on the EV-100 and the 12V supply cable which supplies the SeaTalk
ng
backbone.
9.
Check the green light on the SeaTalk1 to SeaTalk
ng
is on (and flashing periodically).
10.
Turn on the AP-WRC4 using the rocker switch at the bottom of the base unit.
11.
Check that the blue
‘OP’
LED on the AP-WRC4 flashes 3 times after being turned on.
12.
Check the orange ‘
ST
’ LED
is off and remains off after 5 seconds
. If the ‘
ST
’ LED turns on, wait
for several more seconds and verify that it eventually turns off.
13.
To finish off, mount the AP-WRC4 base unit and SeaTalk to SeaTalk
ng
Converter in
accordance with their respective manuals and tidy up the cabling. The AP-WRC4 User
Manual is available from the ‘Downloads’ page at https://
www.madmanmarine.com
Figure 3 - AP-WRC4 Installation
Items marked with * are part of Raymarine SeaTalk
ng
to SeaTalk1 Converter Kit Part No. E22158
SeaTalk
ng
to SeaTalk1
converter
*Terminator
*Blanking Plug
*SeaTalk1 Cable
*Blanking Plug
