Madimack INVPLUS1100, Инструкция по установке и эксплуатации

Страница: 6 / 12

3
4. CONNECTING TO POOL PUMP
Please follow these steps and the wiring diagram for the correct connection. The warranty
may be compromised if the device is not installed in accordance with instructions described in
this manual.
Only ONE pump can be connected to the inverter. Please do not connect any other appliance
to the output.
Mark the hole locations on the wall with the template provided, drill and insert the expansion
plugs supplied, fit the screws and hang the device on the screws.
4.1 Turn off all electrical supply to the pool pump, unplug the pool pump it from the main
switch or at the chlorinator which provides electrical power to the pump.
4.2 Plug the pool pump into the device’s “Power socket” see fig 3 below (PUMP
CONNECTION ONLY).
4.3 Plug the device into the main switch/chlorinator/timer connection where the pump was
originally plugged into.
4.4 Switch power back on.
4.5 Ensure chlorinator/timer is active which will put power the controller
4.6 Now the device is ready to operate and will illuminate
Fig. 3
Above figure is for reference only, plug & socket may vary for different countries/regions.
Power plug
Pump socket
12mm
Screw
Screw
Expansion plug