2
1-2.Features
1.Closed loop sensor feedback, temperature is controlled by zero
voltage triggering mode and is not affected by air volume. Powerful, rapid
heating up, accurate and stable.
2.Wide range of hot air volume adjustment.
3.Electromagnetic inductor switch inside the handle starts the hot air when
the handle is picked up. The rework station is set to an idle mode when the
handle is placed back to the holder.
4.Increased heating element life and safety with built in automatic cooling
feature.
5.Compact design, occupy less space.
1-3.Applications
1.Suitable for soldering and desoldering various SMD components, such as
SOIC,QFP,PLCC,BGA chips.
2.Can also be used for heat shrinkage, paint and sticker removal, preheating,
sterilizing, glue connecting etc.
2.Installation and Operation
2-1.Handle holder assembling
1.Install and tighten the four screws as shown in the diagram as per your
personal habits.
2.Remove the two screws which fix the handle holder on the left or right
side of the unit.
3.Align the two holes of handle holder to the two corresponding holes on
the unit, tighten the removed two screws.
4.Place the handle assembly on the handle holder and check the condition
carefully.
