Page 2
For technical questions, please call 1-888-866-5797.
Item 64918
Specifications
Maximum Input Air Pressure
100 PSI
Gauge Scale
0 –100 PSI in 2 PSI increments
0 –700 kPa in 10 kPa increments
Included Spark Plug Adapters
10 mm, 12 mm and 18 mm Adapters
Adapter Hose
24" with 14 mm threads
Important Safety Information
1.
Keep work area clean
.
Cluttered areas invite injuries.
2.
Observe work area conditions
.
Do not use machines or power
tools in damp or wet locations.
Don’t expose to rain. Keep work area
well lighted. Do not use electrically
powered tools in the presence
of flammable gases or liquids.
Be aware of the inherent dangers
of working on a gasoline engine.
3.
Keep children away
.
Children must never be allowed in the
work area. Do not let them handle
machines, tools, or extension cords.
4.
Store idle equipment
. When not
in use, tools must be stored in a dry
location to inhibit rust. Always lock up
tools and keep out of reach of children.
5.
Use the right tool for the job
.
This cylinder tester is intended for
use in gasoline powered engines.
Do not modify this tool and do
not use this tool for a purpose
for which it was not intended.
6.
Dress properly
. Do not wear loose
clothing or jewelry as they can be
caught in moving parts. Protective,
electrically nonconductive clothes and
nonskid footwear are recommended
when working. Wear restrictive hair
covering to contain long hair.
7.
Wear ANSI-approved impact
safety goggles when working
on gasoline engines.
8. Be sure to work in a well ventilated
place, or pipe exhaust gasses to the
outdoors. Guard against exposure to
Carbon Monoxide, which is an odorless,
colorless gas produced by gasoline
engines. Carbon Monoxide exposure
may cause serious injury or death.
9.
Do not overreach
. Keep proper footing
and balance at all times. Do not reach
over or across running machines.
10.
Maintain tools with care
. Keep tester
threads sharp and clean for better
and safer performance. Follow
instructions for lubricating and changing
accessories. The gauge hose and
adapters must be kept clean, dry, and
free from oil and grease at all times.
11.
Prevent accidental starting.
Turn
off engine and disconnect ground
(negative) battery cable before use.
12.
Check for damaged parts
. Before
using any tool, any part that appears
damaged should be carefully checked
to determine that it will operate
properly and perform its intended
function. Any part that is damaged
should be properly repaired or
replaced by a qualified technician.
