Page 4
For technical questions, please call 1-888-866-5797.
Item 63729
External Grip Jaw Operation
1. Use the Bolts and Nuts to attach
the Jaws to the 2 or 3 Jaw Puller
Adapters (6/10), as needed.
Thread the adapter onto the
Spindle until non-threaded end of
the Spindle exits the Adapter.
Note:
To grip the work piece externally,
claws of the Jaws should be facing inward,
as shown in Figure C and Figure D.
2. Clamp the Jaws onto the object to be
pulled. Turn Lock Nut (3) clockwise
against the end of the Jaws, forcing
them closed, causing the claws to be
pushed inward against the work piece.
Tighten the Bolts and Nuts firmly.
3. Push the Slide Hammer towards the
work piece, and then forcefully pull
it back towards the cross bar end.
Repeat and adjust force as needed.
Jaws (4)
Lock Nut
(3)
Spindle (11)
2-Jaw
Puller
Adapter
(6)
Bolt
and Nut (1)
Figure C
Spindle (11)
Lock Nut
(3)
Jaws (4)
3-Jaw
Puller
Adapter
(10)
Bolt
and Nut (1)
Figure D
Internal Grip Jaw Operation
1. To use Jaws to grip an object from the
inside, thread the Lock Nut onto the
spindle with the conical side first.
2. Use the Bolts and Nuts to attach
the Jaws to the 2 or 3 Jaw Puller
Adapters (6/10), as needed.
Thread the adapter onto the
Spindle until non-threaded end of
the Spindle exits the Adapter.
Note:
To grip the work piece internally,
claws of the Jaws should be facing outward.
3. Back-off the Lock Nut (3) to permit the
jaws to be attached to the workpiece.
Turn the Lock Not forward, causing
the claws to expand and grip the work
piece firmly. Tighten the fasteners.
4. Push the Slide Hammer towards the
work piece, and then forcefully pull
it back towards the cross bar end.
Repeat and adjust force as needed.
