Parts List
(1) Nose Cone
(1) Body Tube (22" Long)
(2) Ram Jet Nose Cones
(2) Pod Tubes (6.5" Long)
(1) Laser cut Bass Wood Sheet
(2) Centering Rings
(1) Motor Tube (3.75" Long)
(1) Thrust Ring (1/4" Long)
(1) Motor Clip
(1) Motor Spacer (1" Long)
(1) Nylon Shock Cord Section
(1) Kevlar Shock Cord Section
(2) Launch Lugs
(1) Decal Sheet
(1) 18" Nylon Chute
(3) 1/8" x 1/4" x 24" Balsa Strips
You’ll need these items to complete this kit
Please make sure you read all directions and
understand how to assemble your model before you
start construction. It is also a good idea to test fit each
part before assembly - some manufacturing tolerances
may require light sanding before final assembly.
Laser cut parts will exhibit varying amounts of charring
on the edges depending on the density of the wood.
The charred edges do not interfere with bonding and do
not need to be cleaned before assembly. In most cases
the charring will be cleaned up during sanding for
finishing and painting.
B
5 Minute Epoxy
Wood Filler and Paint
Lead Shot
for balance
Wood Glue & Original
Brown Gorilla Glue
Electrical
Tape
120/220 Grit
Sandpaper
Masking Tape
Hobby Knife and Pencil
Wood
Filler
Spray
Paint
Lead
Shot
Glue
Epoxy
Epox
Mini Bomarc Assembly
©
2015 Madcow Rocketry™
Nose Cone and Parachute
Step 33 - Using a sharp knife, cut a hole
in the bottom of the nose cone shoulder
opposite the shock cord attachment.
Step 34 - Insert 4.75oz. of lead shot into the nose cone. Check
the C/G point. When it is 13.2” from the nose cone tip, drip some
Epoxy or Gorilla Glue over the lead shot to hold it in place. A few
drops of water will activate the glue and cause it to expand. Let
the nose cone weight dry with the tip down.
Step 35 - Pull the shock cord out the front end of the body tube.
Slide the eyelet on the parachute protector 1/3 the way down the
shock cord. Tie a single overhand knot over the eyelet.
Tie an overhand loop 2” above the chute protector. Attach the
parachute to the loop knot.
Step 36 - Tie the nylon line to the base of the nose cone with a
square knot.
Your model is now ready to paint and fly.
Now go have some fun!
To Rocket
Body
To Nose Cone
Attach Parachute
to Loop Knot
Remove
Grey Area