Mad Bean Pedals Rabbit Hole, Быстрый старт

Страница: 7 / 10

7
Build Guide
The Rabbit Hole is comprised of two PCBs – the main board and the pots board. Before you start
populating, gently break the two boards apart at their bridge point.
Use your wire cutter to clean up edges/leftover PCB material so they are flush. These two PCBs will
be wired together later on.
Populate the main board and solder all your parts in. You should avoid the use of sockets as they will
make components too tall to fit in the 1590A enclosure; solder all components directly to the PCB.
The pots are directly soldered to the second board. The SUS and VOL pots are soldered to the top
and the Tone pot is soldered to the bottom to form the typical triangle knob arrangement. Finally,
solder wires to connect the two boards together (wires 1-9). These wires should be about 1 – 1.5”
long each to allow the pot board to bend at a 90° angle to the main board. When assembling the final
pedal, the main board will rest on top of the input and output jacks while the pots board will bend over
and attached with nuts to the enclosure.