Mad Bean Pedals Aquababy, Руководство пользователя

Страница: 5 / 11

Parts Guide
Mini 1uF electrolytic caps (recommended but not absolutely necessary):
https://www.mouser.com/ProductDetail/Lelon/SG010M1HBK-0407P?qs=%2Fha2pyFadug8BwuCWCMjxIcLopjZQ3XC -
J7%2FDZotRQwdYDLhCTplE8Q%3D%3D
MPSA18:
http://smallbear-electronics.mybigcommerce.com/transistor-mpsa18/
V571 (sub for NE570):
http://smallbear-electronics.mybigcommerce.com/ic-v571d/
Xvive MN3005:
http://smallbear-electronics.mybigcommerce.com/mn3005-re-makes-xvive-audio/
MN3101 (currently out of stock):
http://smallbear-electronics.mybigcommerce.com/ic-mn3101/
Bourns 3362p 22k:
https://www.mouser.com/ProductDetail/Bourns/3362P-1-223LF?qs=sGAEpiMZZMvygUB3GLcD7v%2F2K2JTtKgbVP -
DHLENkzyQ%3D
Bourns 3362p 10k:
https://www.mouser.com/ProductDetail/Bourns/3362P-1-103LF?qs=sGAEpiMZZMvygUB3GLcD7k%252Bod3ZqvEIQboR -
RPdOKB6M%3D
Bourns 3362p 1M:
https://www.mouser.com/ProductDetail/Bourns/3362P-1-105LF?qs=sGAEpiMZZMvygUB3GLcD7kddhVJPyV2kST -
8Lo8Gl%252B%2F8%3D
16mm Solder Lug pots:
http://smallbear-electronics.mybigcommerce.com/alpha-single-gang-16mm-solder-terms-linear-audio-taper/
If you want to build the Aquababy with modulation like I did (see my build pic later in this doc) this is the dual pot I used:
http://smallbear-electronics.mybigcommerce.com/alpha-dual-gang-9mm-pc-mount-dual-concentric/
R35 is not used on the DM-2, but some analog delays do use a resistor there. Supposedly it can improve the THD from
the compander although I have yet to hear an actual difference (perhaps it’s only be detectable on a scope). In any case,
if you want to try it yourself, use a 20k resistor for R35. Otherwise just leave it empty.
Like the Aquaboy, you can run the Aquababy at 15v, but it might be very difficult to fit a charge pump in such a small en -
closure. If you intend to run the Aquababy at 15v, change R13 and R14 to 36k from 10k.
Notes