DMK-1 Installation Guide
REV
–
1.0
[34-2900-0065-9 ]
6
|
P a g e
3.2.5
Remove the adhesive cover on one side of foam seals. Place them over the conduit setscrew adapters on
the outside of the enclosure as pictured.
3.2.6
Install the exhaust tube into the “downstream” setscrew adapter with the open end of the 45
-degree cut
facing downstream.
3.2.7
Install the appropriately sized sampling tube (not provided) into the “upstream” setscrew adapter with the
ports facing upstream.
Important:
•
The sampling tube MUST extend at least 2/3 into the width of the duct.
