- 15 -
Calibration
When the touch operation is not sensitive or valid, you should
calibrate the touch screen using the calibration setting function.
Adjust the response positions of the touch panel as followings:
1. Touch [ Start ] to enter.
2. Touch [ Cancel ] to exit.
3. Press and hold the center of [
+
] for 2 seconds, the [
+
] will move
automatically.
4. Aim at center of [
+
], follow the path as shown in the figure. Once
steps 1-5 are complete, touch [ OK ] to exit calibrating mode.
SWC Programing
The following controls are available for most vehicles:
1
2
3
4
5
6
Volume -
Mute
Next
Prev
Play
7
8
9
10
11
12
Home
Preset -
Band
Source
Answer
Touch [ Enter ], the SWC menu will display.
Up to 12 steering wheel control functions can be programmed via the built-in SWC interface. Not
all functions may be supported for each vehicle.
1. Before programming, you need to clear / reset the SWC interface by pressing the [Reset] icon.
2. Define the functions of the steering wheel controls by pressing a number 1 ~ 12, then press a
function between the available ones. A check mark corresponding to the number and function
will be displayed. Repeat the confusion until completing all the steering wheel control functions.
Settings
Note:
Define only the functions available on the steering wheel.
3. To complete the programming, tap the [Program] icon.
It will then be required to push each button on the OE
wheel (for 1 second), so that the unit can store the
corresponding function.
4. SWC learning / programming is now complete.
5. Touch [ ] to exit.
M-DL4000 User manual_ENG.indd 15
08/06/2017 15:41:12
