Use of Bi-wiring
Substitute Installation
Standard installation with grille kits
Input Integra
Installation system for FIAT car`s
Instruction for use
Installation system for AUDI, TOYOTA car`s
Standard 2 way system
connection
Connect the terminals
marked INPUT INTEGRA
directly to the amplifier.
Cut the two Tweeter cables coming from the Magnet cover
Example of Bi-wiring connection with electronic crossover
Head Unit
Power Amplifier
Power Amplifier
Electronic Crossover
Integra
Tweeter
Input
Woofer
Input
Pre Output
High Output
(min. 3kHz)
Low Output
Input
Integra
Tweeter
Input
Woofer
Input
TWEETER WARNING: The tweeter
CANNOT reproduce the whole audio
range. You must absolutely use a passive
or electronic crossover with a frequency
cutting not lower than 3kHz.
Input Woofer
Input Tweeter
Versatile unit suitable for replacing car
manufacturers` existing speaker
installation or as a new component with
grille kits protection.
Use the supplied accessories in to grille
kit (fasteners, clips, screw, plastic frame
and grille) according to the desired
installation position.
Any number and combination of fixings
cam be used to ensure satisfactory
installation.
Where necessary use the plastic frame
as a template.
Installation system for MERCEDES, VOLKSWAGEN car`s
The Integra are prepared for bi-wiring connection.
This allows you to separate the Tweeter from the Woofer using external crossover.
Active or passive crossovers can be used according to requirements.
The unit is supplied with a passive 6dB/Oct filter thanks to the perfect woofer roll off.
For correctcuse of Bi-wiring please proceed as follows:
Screw
Grille
Mounting Ring
Sprung Steel Fastener
Clips
Use the screw clips in any combination, with or
without the plastic frame.
These clips can be used either way up depending
on installation requirements.
Use the non-screw clips to install the woofer
in the dashboard or other locations which do
not require screws.Insert the clips in the
small holes on the side of the woofer
according to your requirements.
