Rev. Date 111714 © 2014 MacroAir Technologies Toll Free: 866 668 3247 Fax: 909 890 2313 www.macroairfans.com
25
FRONT
SAFETY SCREEN & SAFETY CABLE
Front Safety Screen
• Line up the struts of the front screen with the struts of the rear screen.
• Attach the screens together by inserting the included sheet metal screws through the holes in the front screen struts into the holes in
the ends of the rear screen struts.
• Completely tighten one screw at the top, bottom, and each side to hold the screens in place, then tighten all of the screws. Be careful
not to strip them out.
Safety Cable
• Fine-tune the horizontal angle. Make sure the nuts are all completely tight.
• Pivot the fan to the desired vertical angle and securely tighten all the nuts in the pivot section.
• Note
: Always allow one to two inches of clearance between the safety screen and the walls or ceiling.
• Check that all of the nuts and bolts are completely tight.
• Thread the safety cable through the center hole on the motor mount and pivot below the gearbox/motor and attach securely to a
nearby wall or ceiling. MacroAir recommends using an eyebolt securely attached to the wall or ceiling to anchor the safety cable; this
is not included with the fan.
