macro machines storage strip manual
____________________________________________________
Installation______________________________________________
Connect the 16-pin ribbon cable to the module with the orientation of the red
stripe matching the line marked -12.
Control data from the Storage Strip is sent
along the CV rail of the busboard. Ensure all modules to be controlled by the
Storage Strip are on the same busboard. A 2HP bus access utility module allowing
chaining of the CV and Gate rails will be available soon.
Warning: Do not install the Storage Strip on the same row as any Doepfer modules
which are configured to send voltage to the CV/Gate bus.
There are 2 male header pins labeled zoom, to allow compatibility with Mungo
Enterprises 0 line of eurorack modules, use the provided female jumper cable to
connect up to 2 Mungo modules directly to the Storage Strip. To chain additional
Mungo 0 modules, connect a female jumper cable to the zoom chaining pin on the
back of any directly connected Mungo 0 module.
____________________________________________________
/// 2014 macromachines.net
