HG 20R(Rigid) and HG20F (Flexible) OIL CONTROL GUNS
0003
INTRODUCTION
Thank you for purchasing a Macnaught oil dispensing gun
complete with either a flexible or rigid extension. The
Macnaught oil dispensing guns have been designed for use
with engine oil, gear oil, automatic transmission fluid,
anti-freeze/anti-boil and compatible fluids.
Macnaught also manufacture a complete range of ratio oil
pumps and retractable oil hose reels, greasing equipment
and accessories to fulfill all your fluid handling and greasing
needs requirements.
GENERAL INFORMATION
This manual assists you in operating and maintaining your
new oil control gun. The information contained will help you
ensure many years of dependable performance and trouble
free operation.
Please take a few moments to read through this manual before
installing and operating your new oil control gun. If you
experience problems with this product, refer to the trouble
shooting sections of this manual. If you require further
assistance please contact your local Macnaught distributor
or authorised Macnaught service centre.
IMPORTANT INFORMATION
READ THIS INFORMATION
CAREFULLY BEFORE USE.
Your safety is important to us. Please read and follow all
safety instructions listed inside.
Some of these instructions alert you to the potential for
personal injury. “Cautions” listed throughout this manual
advise of potential practices or procedures which may
cause damage to your equipment.
Ensure all operators have access to adequate instructions
about safe operating and maintenance procedures.
Do not exceed the maximum working pressure of 6900
kPa / 1000 psi / 69 bar.
CAUTION
Do not hit the oil control gun if it fails to operate. Refer to
“trouble shooting guide” or return the unit to your nearest
authorised service centre.
Never point the nozzle at yourself or anyone else.
Never exceed the pressure rating of any component
installed in the System.
Before every use check all hoses for signs of wear, leaks
or loose fittings. Tighten all fluid connections regularly and
replace weak or damaged hoses
Before attempting any repairs or maintenance of this
product firstly disconnect the air supply from the oil pump,
then release the oil line pressure by squeezing the lever on
your oil control gun.
ASSEMBLY
Use teflon tape (or suitable thread sealant ) when connecting
the oil control gun to an oil hose.
1
OUTLET NOZZLE OPERATION
When fluid flows through the gun the outlet nozzle will
automatically open. When the fluid flow stops the outlet
nozzle will automatically shut
HANDLE OPERATION
To latch the handle, squeeze the lever, push the button and
then release lever.
To release the latch in manual mode simply squeeze and
release lever.
Please read and retain this instruction manual to assist
you in the operation and maintenance of this quality product.
INSTRUCTION MANUAL
HG616
0206
