996553
–
Revision A
P a g e
|
11 of 17
Installing the Hoist
The section below will cover the Installation of the Hoists into their specified Tracks. Refer to the Table in the introduction to
determine if the Hoist available is compatible with the pre-installed track. Do not use a variant Hoist and track together as they
are incompatible.
To install the TX Hoist, follow the guidance below:
1.
Complete all the relevant steps in section 4.1.
2.
Complete all the relevant steps in section 4.2.
3.
A step ladder is recommended for easier and safer installation.
4.
Using both hands to support the Hoist, align the Hoist horizontally with the Ceiling Track entrance. (Figure 23)
5.
Ensure the charging port is
leading
into the track. The charging port is circled in (Figure 24)
6.
Carefully place the Hoist wheel assembly into the track without damaging the hoist components. (Figure 25)
7.
Using the wheels, slide the Hoist away from the end of the ceiling track for safety. (Figure 26 and 27)
8.
Reverse the Steps in section 4.1 to secure the ceiling track entrance. Fitting the end stop, safety bolt and end cap
correctly.
9.
Hoist Installation Complete.
To remove the Hoist, follow the steps above in reverse.
(The images in this section all refer to a Track Type 1 installation, but the same process applies for all the remaining track types)
Figure 23
Figure 24
Figure 25
Figure 26
