7
OWNER’S MANUAL
OWNER’
S MANU
AL
CR2-X BAR PRO: Rear Panel Features
4. 1/8" Stereo Input Jack
Connect a line-level signal from a smartphone,
MP3 player or other signal source to this input jack
using an unbalanced 1/8" connector.
It is wired as follows, according to standards
specified by the AES (Audio Engineering Society):
Stereo 1/8" TRS
Sleeve = Shield (Ground)
Tip = Left Channel
Ring = Right Channel
5. USB I/O
Since the CR2-X Bar Pro is a “Premium Desktop PC
Soundbar with Bluetooth®,” the USB connection will
(most likely) be one of the most widely used features.
In short, it works as an interface that allows audio to
stream from the CR2-X Bar Pro via computer.
This is the connection that will be used for gaming,
watching movies and fun cat videos, playing music
or just about any other sound that is emitted from
your computer.
Connect the USB-C side of a USB cable to
the CR2-X Bar Pro and the USB-A side to the
computer’s USB port.
Don’t forget to change the output to ‘CR2-X Bar Pro’
via Settings on your computer.
CR2-X Bar Pro’s USB connection is audio only.
It is not a source of power.
1. Power Connector
CR2-X Bar Pro has a universal external power supply
that accepts any AC voltage ranging from 100 VAC
to 240 VAC. No need for voltage select switches.
It will work virtually anywhere in the world.
That’s why we call it a “Planet Earth” power supply!
It is less susceptible to voltage sags or spikes compared
to conventional power supplies, and provides greater
electromagnetic isolation and better protection
against AC line noise.
Attach the AC connector (the smaller, shorter
cable that plugs into the wall) to the power supply
adapter (the bigger, longer cable that plugs into
the CR2-X Bar Pro).
The power supply adapter may be connected
to the CR2-X Bar Pro by pushing it into the power
receptacle on the rear panel and plugging the other
end into a live AC outlet. The LED on the power supply
will illuminate blue to indicate that it is receiving power.
Only use the factory-authorized power
supply that came with the CR2-X Bar Pro.
2. Power Switch
Press the right side of this rocker switch inwards
to turn on the CR2-X Bar Pro. The corner pieces on the
front panel will illuminate green, confirming success.
Additionally, it will state, “Power on. Bluetooth pairing
mode.” Press the left side of this rocker switch inwards
to turn it off.
3. To Sub
Not much of a surprise here, as we would like you
to connect this output to the input of a subwoofer
using an 1/8" connector.
When connected, the CR2-X Bar Pro
automatically shifts to sub mode, resulting
in a roll-off of the low frequencies.
Of course, we would highly recommend the CR6S-X or
CR8S-XBT subwoofer; see the hookup diagram on page
6 and check the Mackie website for more information!
2
3
4
5
1
Содержание CR2-X BAR PRO
Страница 1: ...OWNER S MANUAL...