MachineryHouse C6241, Инструкция по эксплуатации

Страница: 12 / 93

11
illustration 2-5
2-3 Construction of the Ground
Due to the recent tendency of
utilizing Utilizing Ultra-Hard Alloy
Steel tools, it surely increase the
speed of heavy cutting comparing to
the previous steel tools. But, in the
mean time, it easily happens to the
vibration of the machine. For assuring
better cutting result, it requires a very
strong and steady construction of
ground. (Please refer to right
illustration of construction of ground)
2-4 Cleaning
All our machine are with a anti-rust
oil layer before delivery. After inspection, please remove to clean the slideways, lead
screw, shafts and other polished parts by a soft cloth with cleanser (do not use
gasoline or cellulose solvent to avoid fire or explosion). Then apply a thin layer of oil
for lubricating purpose. Push those movable parts such as: Tool Holder, Tailstock back
and forth.
2-5 Level Adjustments
Wait until the fixture screws and cement completely concrete to start adjusting lathe
bed horizontally. In doing this, place a leveling instrument (with accuracy 0.02 mm/
1000mm) upon the grooves of lathe bed to confirm the level of right and left side.
Same procedure for the front and rear leveling.
The allowance of level should be adjusted within 0.04
mm/ 1000mm.
Screw up the nuts, check again, if
whatever errors occur due to tightly
screw-up thereinafter, adjustment may
require to be done again.
As per illustration indicated, place
two leveling instruments on lathe bed to
check the level by pushing them back
and forth in its possible maximum
moving range.
illustration 2-3
Page 12 Instructions Manual for CL-40A (L600) 01/09/2017