MACHINE SOLUTIONS BEAHM DESIGNS 43-B, Руководство пользователя

Страница: 5 / 18

© Copyright. Machine Solutions Inc. All Rights Reserved PM-62319 REV B 5
Equipment User Manual
Die Head Replacement
Caution: ensure the die heads are cooled to within 15 degrees °F of ambient
temperature before proceeding with replacement.
Required Tools and Equipment
2 open end or similar wrenches
1. Remove the 4 screws holding the heat shield.
2. Remove the heat shield.
3. Loosen the clamping nut and bolt located at the top and bottom of the heater housing.
4. Remove the existing die from the housing and replace it with alternate size die.
5. Tighten the clamping nut and bolt until the die is secure in the housing.
6. Reinstall the heat shield.
Parameter Settings
Cooling Air ON Toggle
•
Place toggle in the up position for cooling air On, and toggle down for
cooling air Off.
Cooling Air Flow Adjust
•
Rotate the Cooling Flow valve counterclockwise to increase the cooling
air flow, and clockwise to decrease the cooling air flow.
System Operations
CAUTION: Die housing and drawing dies will become hot during operation and,
depending on temperature set-point, can cause severe skin burns if contact occurs.
1. Switch main power on.
2. Set die temperature on temperature controller by pressing the UP button once to see
“SP1” displayed. Press the Enter button to display temperature. Use Left/Right arrows to
set desired temperature. Once the desired temperature is set, press the Enter button to
return to home.
3. Pass end of tubing through the necking die and grasp at opposite side.
4. Draw tubing through die at a speed that produces the desired tubing o.d.
5. To aid in obtaining tubing diameter, position the cooling air nozzle near the exit of the
drawing die and switch cooling air “on” as tubing is drawn through the die.