Machine Mart KING 125, Инструкция по эксплуатации и техническому обслуживанию

Страница: 10 / 24

10
USING YOUR POWER WASHER
• Stand on a stable surface and grip gun/spray wand firmly with both
hands.
• Do not allow vehicles to drive over the hoses.
• Never obstruct the exhaust in any way.
COLD WATER OPERATION
1. Turn on the water supply tap to supply water to the power washer.
2.
Fig. 6
Set the Hot / Cold selector switch
(I / 0/II) to (I) to start the power
washer operating with cold water.
See Fig. 6.
• Pump will start
3.
Fig. 7
Take hold of the lance and press
the trigger (A) as shown in Fig. 7.
• Expect the gun to kick when
the trigger is pulled.
• Check that the water jet is
strong and continuous;
otherwise, remove the nozzle,
clean it and put it back in
place.
4. Release trigger to stop water flow.
NOTE: The power washer will then automatically go into bypass mode.
WARNING: FAILURE TO TURN ON THE WATER WILL CAUSE DAMAGE TO THE
HOT WASHER
WARNING: DO NOT ALLOW THE POWER WASHER TO OPERATE IN BYPASS
MODE FOR MORE THAN 5 MINUTES. OVERHEATING CAN CAUSE
DAMAGE TO PUMP.