34
EN
MAINTENANCE
EXECUTION OF THE SHARPENING
8
.2 - Blade sharpening
Accurately clean the machine as indicated in the previous paragraphs before
proceeding in the operations.
Sharpening can be performed up to a reduction of 12
mm of the blade’s diameter nominal. Over that value
IS MANDATORY TO CHANGE THE BLADE entrusting
the operation ONLY to personnel authorized by the
manufacturer.
1. Carefully clean the blade with denatured
alcohol to degrease it
;
2. Operate the graduated knob (4) by
turning it to the left to bring it to the
maximum opening
;
3. Remove the sharpener from the bag
container provided, unscrew the
knurled knob of the sharpener and
insert the threaded metallic pin into
the hole (4a) specially crafted on
the product carriage so that the two
emery-wheels vare toward the blade
to be sharpened helping the operation
by pressing the finger on the lower
9
.1 - Versions equipped with sharpener to be applied
WARNING: Cutting hazard! Use protective cut- and tear-
resistant gloves and perform all operations with extreme care.
PAY ATTENTION AT ALL TIMES!
wheel button (16a).
The lower wheel must remain inserted
for about half of its diameter between
the blade on which it rests, and the
regulatory plan
;
4. Insert the plug in the socketand start
the blade while holding the product tray
and the sharpener in the aforesaid
position, using the handle (16);
35
Fig. 19
EN
EXECUTION OF THE SHARPENING
5. Allow the blade to rotate for about 30 to 40 seconds and then use the switch to stop
it checking with a slight shift (using a pencil) to the outside of the blade if the burr is
formed.
We reccomend to perform this check very carefully as
the blade is very sharp.
Ascertained the formation of the burr, restart the blade and hold for 10 seconds the
wheel button (16b).
4a
16b
4
16a
16
403002-004-005-007-008-009-010 G21E
33/47
