Mach Power WL-AC5250-047, Руководство пользователя

Страница: 5 / 20

5
Reset button
If need to restore the WL-AC5250-047 into factory default, please do following procedure: Power on WL-AC5250-047, use a pin to press
and hold the reset button until all LED becomes quick-flash from slow-flash.
Then release the button and wait WL-AC5250-047 to reboot to its factory default settings. After that, the default IP address of WL-
AC5250-047 is still 192.168.10.1,default user name and password are both admin RJ45 Ports: 5x10/100M/1000Mbps auto-negotiation
RJ45 Ethernet Port; Support any connection devices in 10/100M/1000Mbps bandwidth;
Notice
LAN/WAN port is LAN port only on the default mode, only when WAN setting is enabled then LAN/WAN port will change to WAN port;
2.3.2 Real Panel
DC Jacket
DC Jacket located on the right side of WL-AC5250-047’s real panel, input power should be ac power 100-240V~ 50/60Hz 0.3A
Anti-thunder ground connection:
Please deploy ground connection to avoid lightening stroke, by copper core cable in yellow and green jacket;
For detailed installations please refer to related manuals, like “Anti-thunder installation guide in devices”
Attention:
Please use original power cord for installation; Set locate power outlet near the devices, to make safer and easier installation and
operation
2.3.3 Connection
Please power the AC controller, and connect the AP in following working diagram:
DSL WL-AC5250-047 SWITCH
AP
AP
AP
Please note, in above picture, can make Wireless AP connect with PoE switch, PoE switch’s uplink port connect with AC controller’s
WAN port, total connection will be based on the application environment.
CHAPTER3
CONFIGURATION GUIDE
3.1 Login Web Interface
Please confirm the following points before login WL-AC5250-047:
1. Connect the managment host (PC) to LAN port of AC controller or UP-link port of switch in the whole networking.
2.
The management host(PC) has been properly installed IE 7.0 or higher browser version
3. The management host’s IP address has been set the same network segment with WL-AC5250-047, namely 192.168.10.X (X is betwe-
en 2-254 arbitrary integer Number), a subnet mask of 255.255.255.0.
4. In order to ensure a better effect of Web interface displays, it is recommended to adjust the display resolution to 1024 × 768 or
more pixels.
Operation Steps:
A.
Open IE browser, Input http://192.168.10.1 in the address bar to login WL-AC5250-047 Web management interface.
B.
Now you must enter username and password, the factory default is:
Username: admin
Password: admin
click “OK”