MacDon R85, Инструкции по разгрузке и сборке

Страница: 27 / 55

UNLOADING AND ASSEMBLY
169561
25
Revision C
C. 3-POINT HITCH SETUP
a. Attach the 3 point hitch adapter (A) to the APT
hitch with pin (B). The installation is similar to
that described in the previous section.
b. Secure pin (B) with clevis pin (C), washers,
and cotter pin.
c. The arms on the adapter (A) can be set up to
suit Category II and IIIN, or Category III tractor
hitch arms:
1. Remove pins (D).
2. Remove bolts (E) (3 per side).
3. Flip outer plate (F), and inner plate (G) on
each arm.
IMPORTANT
The inner plate (G) has a smaller joggle
than the outer plate (F). Always maintain
the proper locations.
4. Re-install bolts (E).
5. Replace pins (D).
NOTE
Bushings (H) on pins can be removed to
suit hole size in tractor hitch arms.
d. Assemble PTO driveline male half (J) onto
driveline (K) on APT hitch. Push male half so that
driveline is at its fully compressed length.
e. Locate driveline in hook (L).
CATEGORY II or IIIN
F
E
G
D
CATEGORY III
F
E
G
D
H
C
B
A
J
K
L