215026
40
Revision A
1000812
A
B
C
Figure 3.47: Header Support
20. Back the windrower slowly away from header.
21. Reinstall clevis pin (A) through support (C) and secure with
hairpin (B). Repeat for opposite side.
3.4.2
Removing Forming Shield
WARNING
To avoid bodily injury or death from unexpected startup of the machine, always stop the engine and remove the key
from the ignition before leaving the operator
’
s seat for any reason.
1.
Stop engine, and remove key from ignition.
1030490
A
B
C
D
Figure 3.48: Rubber Strap Securing Forming Shield
onto Windrower Leg
2.
Remove and retain hairpin (A) and washer (B) from straight
pin (C).
3.
Pull rubber strap (D) away from straight pin (C).
4.
Lower rear end of endshield.
5.
Reinstall washer (B) and hairpin (A) on straight pin (C) for
storage.
6.
Repeat Steps
to
at the opposite side.