MacDon R113, Инструкции по разгрузке и сборке

Страница: 106 / 110

214075
100
Revision A
Predelivery Checklist
Perform these checks and adjustments before delivering the machine to your Customer. If adjustments are
required, refer to the appropriate page number in this manual. The completed Checklist should be retained by
either the Operator or the Dealer.
WARNING
Do NOT operate the machine with the driveshields open. High speed rotating components may throw
debris and could result in death or serious injury.
CAUTION
Carefully follow the instructions given. Be alert for safety-related messages that bring your attention to
hazards and unsafe practices.
Serial Number:
Table .11 Rotary Disc Header for Self-Propelled Windrower Predelivery Checklist
✔ ✔ Item Reference
Check for shipping damage or missing parts. Be sure
all shipping dunnage is removed.
—
Check for loose hardware. Tighten to required torque
if applicable.
9.4 Torque Specifications, page 88
Check main drive belt tension. 7.1 Checking Conditioner Drive Belt, page 49
Check skid shoes are evenly set. 7.2 Checking Skid Shoes, page 51
Check side forming shields evenly set to
desired position. 7.10 Checking Forming Shield Deflector Position,
page 64
Check rear baffle is about mid-position. 7.9 Checking Conditioner Baffle Position, page 63
Check conditioner roll gap (roll conditioner).
7.7 Checking Roll Gap, page 60
Check conditioner roll tension (roll conditioner).
Check conditioner roll timing hardware is securely
tightened (roll conditioner).
7.3 Checking Roll Timing, page 52
Check that cutterbar doors are unbolted from centre
channel frame, shipping wire is removed from
cutterbar curtains, and cutterbar curtains are
hanging properly.
4 Unpacking Curtains, page 41
Grease all bearings and drivelines. 6.1 Lubrication Procedure, page 48
Check conditioner roll timing gearbox lubricant.
7.4 Checking and Adding Conditioner Roll Timing
Gearbox Lubricant, page 55
Check cutterbar lubricant.
7.6 Checking and Adding Cutterbar Lubricant, page
57