214497
28
Revision D
1027672
A
B
Figure 3.47: Cutterbar
–
Bottom View
15. If shims (A) were removed during disassembly, install them
at this time.
NOTE:
The same number of shims must be installed on both sides
of the cutterbar. A maximum gap of 2 mm (0.08 in.) is
allowed.
16. Install two bolts with two washers (B) into end of cutterbar
through holes on the header frame. Snug bolts but do
NOT
tighten at this time.
NOTE:
These bolts are also used to secure the outboard rock
guard to the frame.
1027652
A
B
Figure 3.48: Alignment Tool on Driven Drum
17. Remove bolts securing alignment tool (A) to drive hub (B).
Lift lower tube and remove tool.
1027250
A
Figure 3.49: Drive Alignment Tool (MD #325683)
18. Install bolt, washer, and nut (A) onto the drive alignment
tool (MD #325683) for storage.