![background image](http://html1.mh-extra.com/html/macdon/m2170/m2170_unloading-and-assembly-instructions_4377466205.webp)
262175
197
Revision A
ϭϬϰϮϮϰϰ
B
A
C
Figure 5.223: Header Support
29. Reinstall clevis pin (A) through support (C) and secure it
with hairpin (B). Repeat this step for the opposite side of
the header.
5.4.6
Removing Forming Shield from the Windrower
The forming shield controls the width and placement of the windrow. The instructions in this section will show you how to
properly remove the forming shield from the windrower.
DANGER
To prevent bodily injury or death from the unexpected start-up of the machine, always stop the engine and remove the
key from the ignition before making adjustments to the machine.
NOTE:
It is
NOT
always necessary to remove the forming shield after detaching the header from the windrower.
1.
Shut down the engine, and remove the key from the ignition.
1030490
A
B
C
D
Figure 5.224: Rubber Strap Securing Forming Shield
onto Windrower Leg
2.
Mark the strap location, remove and retain hairpin (A) and
washer (B) from straight pin (C).
3.
Pull rubber strap (D) away from straight pin (C).
4.
Lower the rear end of the forming shield.
5.
Reinstall washer (B) and hairpin (A) on straight pin (C).
6.
Repeat Step
to Step
on the
opposite windrower leg.
Содержание M2170
