![background image](http://html.mh-extra.com/html/macdon/m205/m205_operators-manual_685753115.webp)
214603
95
Revision A
Setting the Hydraulic Overload Pressure
NOTE:
•
This procedure requires installation of the optional pressure sensor (MD #B5574). For overload pressure
values, refer to pressure sensor installation instructions (MD #169031).
•
To enable sensor, refer to
Switching the Installed Header Sensors ON or OFF, page 134
.
1009974
C###
X###
WINDROWER SETUP?
NO/YES
A
B
C
Figure 3.80: M205 CDM Programming Buttons
1.
Turn ignition key to RUN, or start the engine.
2.
Press PROGRAM (A) and SELECT (C) on cab display
module (CDM) to enter programming mode.
•
WINDROWER SETUP? is displayed on the
upper line.
•
NO/YES is displayed on the lower line.
3.
Press right arrow (B) to select YES. Press SELECT (C).
•
SET KNIFE SPEED? is displayed.
1009991
OVERLOAD PRESSURE?
4000 PSI
C###
X###
D
C
B
A
Figure 3.81: M205 Hydraulic Overload Pressure
4.
Press SELECT (D) until OVERLOAD PRESSURE? is
displayed on the upper line.
•
The current overload pressure is displayed on
lower line.
NOTE:
Pressure range is 17,237
–
34,474 kPa (2500
–
5000 psi).
5.
Press left (B) or right (C) arrows to set hydraulic
overload pressure. Press SELECT (D).
6.
Press PROGRAM (A) to exit programming mode or
press SELECT (D) to proceed to next WINDROWER
SETUP action.
Содержание M205
