214603
85
Revision A
Display (Lower or Upper Line)
Description
##.# HEADER ANGLE
##.# HEADER SENSOR
Angle setting (00.0
–
10.0) header relative to ground
Sensor disabled. ANGLE and SENSOR alternate at 1 second intervals
##.# L FLOAT R ##.#
FLOAT SENS DISABLED
Left and right float setting (0.0
–
10.0)
Sensor disabled
LOAD|
■■■■
| | ####
Bar graph representing hydraulic operating pressure. Full scale is
preprogrammed overload pressure (2500
–
5000 psi). If sensor disabled,
LOAD does not display
10
### °C or F HYD OIL TEMP
### °C or F HYD TEMP
Hydraulic oil temperature
Sensor disabled. TEMP and SENSOR alternate at 1 second intervals
##.# VOLTS
Engine electrical system operating voltage
##.# SWATH COMPR HT
SWATH CO SENSOR
Swath compressor height (00.0
–
10.0); fully raised is 0
Sensor disabled
SCROLL
SUB-MENU (lower line only)
#### DISC RPM
##.# HEADER HEIGHT
LOAD|
■■■■
|
■■■■
| ####
Displays sub-menu after 2 to 3 seconds. Press SELECT to cancel.
Scroll through sub-menu display with CDM switch
Miscellaneous Operational Information
Scroll through display with cab display module (CDM) switch or ground speed lever (GSL) switch.
Display (Upper Line)
Description
HEADER DISENGAGED
Header drive is disengaged
##.# FOOT DISK
AUGER or DRAPER will appear in place of DISK, depending on type of
header attached
IN PARK
GSL in N-DETENT position
< LEFT TURN
■
Indicates left turn when left arrow is pressed on CDM (engine-forward
mode only
11
)
■
RIGHT TURN >
Indicates right turn when right arrow is pressed on CDM (engine-
forward mode only
12
)
■
HAZARD
■
Indicates hazard warning lights are on when hazard button is pressed
on CDM
HEADER REVERSE
Header drive running in reverse
HEADER ENGAGED
Header drive engaged
ROAD GEAR
With HIGH RANGE selected on console switch (engine-forward only
10. The LOAD sensor to monitor knife/conditioner circuit pressure is optional-installed. To monitor reel/auger circuit
pressure, relocate sensor as per kit instruction MD #169031, which is available through your Dealer.
11. If road light kit is not installed, CDM will display E135 LEFT STOP LAMP as a malfunction in cab-forward mode.
12. If road light kit is not installed, CDM will display E134 RIGHT STOP LAMP as a malfunction in cab-
forward mode.
Содержание M205
